Hide Table of Contents

Component Suppression State in Configurations

The column header in a design table to control the suppression state of a component uses this syntax:

$STATE@component<instance>

The column header is not case sensitive.

In the table body cells, type the value for the desired suppression state: Suppressed (or S), or Resolved (or R). You cannot set a component to the lightweight state. If a cell is left blank, the default suppression state is Resolved.

If the component uses a derived configuration, and the table body cell is left blank, the value of the component suppression state used is linked to its parent.

Example of a design table that controls the suppression state of a component:

You can also right-click a component and select Configure component to configure the suppression state of the component.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Component Suppression State
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.