Hide Table of Contents

End Conditions in Configurations

You can change the end condition of extruded features in specified configurations.

To change the end condition of extruded features in specified configurations:

  1. In the FeatureManager design tree, right-click an extruded feature and select Edit Feature.

  2. In the PropertyManager, change the End Condition to the desired settings.

  3. Under Configurations, select the configurations to which you want the new end condition to apply: This configuration , All configurations , or Specify configurations .

  4. Click OK .

    The end condition is applied to the selected configurations.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   End Conditions in Configurations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.