Hide Table of Contents

Replace Face

You can replace faces in a surface or solid body with new surface bodies using the Replace Face tool (Surfaces toolbar). The replacement surface body does not need to have the same boundaries as the old faces. When you replace a face, adjacent faces in the original body automatically extend and trim to the replacement surface body, and the new face trims. See the examples below for information about how to use the Replace Face tool.

Replace Face allows you to do the following:

  • Replace a single face or set of connected faces with a surface body.

  • Replace more than one set of connected faces with the same number of surface bodies in a single operation.

    You must list the face sets for Target faces in the same order as the corresponding Replacement surfaces . Replace Face identifies the pairs of original and replacement faces and performs the replacement.

  • Replace a face in a solid or surface body.

The replacement surface body can be of the following types:

  • Any type of surface feature such as an extrude, loft, fill, and so on.

  • A knit surface body, or a complex imported surface body.

  • Usually wider and longer than the faces you are replacing. However, in some cases when the replacement surface body is smaller than the faces for replacement, the replacement surface body extends to meet the adjacent faces.

The faces for replacement have the following characteristics:

  • Must be connected.

  • Do not need to be tangent.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replace Face
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2012 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.