Hide Table of Contents

Administering Licenses Using a SolidNetWork License Manager

SolidNetWork License Manager supports multiple license clients by distributing licenses to clients on the network. This allows the number of users to exceed the number of licenses by using floating licenses.

This image depicts a typical SolidNetWork licensing installation:

This image illustrates:
  • SolidNetWork License Manager software is installed and activated on the license manager computer only.
  • License client computers do not have any additional SolidNetWork-specific software installed.

    If you specify a SolidNetWork License serial number when installing, SolidWorks Installation Manager identifies that computer as a SolidNetWork license client. SolidWorks Installation Manager prompts you for the SolidNetWork license manager computer name and port number to connect the client to the license manager.

  • The license manager and all license clients must have TCP/IP (Transmission Control Protocol/Internet Protocol) connectivity.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Administering Licenses Using a SolidNetWork License Manager

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS Installation 2013 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS Installation 2013 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.