Hide Table of Contents

Reviewing and Sending ProStep EDMD Model Changes

After an ECAD designer proposes changes to a shared ProStep EDMD file, you can accept or reject the changes in CircuitWorks before building the model with the SolidWorks software. You can then propose your own model changes, and send these proposed changes to the ECAD designer, along with your decisions about the changes proposed by the ECAD designer.

  1. Open the ProStep EDMD file in CircuitWorks.

    Proposed changes to the ECAD file are indicated in the Changes tree located in the lower-left portion of the CircuitWorks navigation tree.

  2. In the Changes tree, review the changes and right-click node for proposed changes:
    • To review a change, select the change in the Changes tree.
    • To accept changes, click Accept Changes.
      After you accept a change at a node, the node appears gray and the its icon includes the Accepted symbol cworkschangesacceptlarge.gif.
    • To reject changes, click Reject Changes.
      After you reject a change at a node, the node appears gray and the its icon includes the Rejected symbol cworkschangesRejectlarge.gif.

    You can accept or reject changes on a node-by-node basis, or on a set of nodes in the Changes tree. When you accept or reject changes to a parent node in the Changes tree, the same review decision is applied to the child nodes in the tree.

  3. Repeat step 2 until you have reviewed all proposed changes.

    After reviewing all proposed changes, you can undo change review decisions: Right-click the top-level changes in the Changes tree and click Undo.
    The prefix for the name of a top-level change is Change.

  4. From the CircuitWorks application, click SolidWorks > Build Model button_build_model.gif (Tools toolbar) to build the model as a SolidWorks assembly.

    After building the model, you are prompted to add messages before your reviewed changes are communicated to the ECAD designer.

    If you have cleared the Sync with ECAD automatically on build CircuitWorks option, you can click Sync with ECAD to send your changes.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Reviewing and Sending ProStep EDMD Model Changes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.