Hide Table of Contents


The Drop Test Setup PropertyManager allows you to setup the following options of the drop test study:
  • You define the drop height (h), the acceleration of gravity (g), and the orientation of the impact plane. The program calculates the velocity (V) at impact from: V = (2gh)1/2. The body moves in the direction of gravity as a rigid body until it hits the rigid plane.
  • You define the velocity at impact (V), the acceleration of gravity (g), and the orientation of the impact plane. The program determines the region of impact based on the direction of the velocity at impact.
No rotations are considered until the initial impact occurs.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Setup

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document SOLIDWORKS 2013 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.