Hide Table of Contents

Face Curves PropertyManager

Selections

PM_face.gif Face Name of the face or surface from which the iso-parametric curve is extracted.
PM_setback_vertices.gif Position Vertex Select a vertex or point to specify the intersection of the two curves.
You cannot drag the vertex.
  Mesh Evenly spaced curves. Specify an integer number of curves for Direction 1 Number of Curves PM_Direction_1_Number_of_Curves.gif and Direction 2 Number of Curves PM_Direction_2_Number_of_Curves.gif. Clear if the curve is not required.
  Position The intersection of two orthogonal curves. Drag the position in the graphics area or specify the percentage distance from the bottom for Direction 1 Position PM_Direction_1_Number_of_Curves.gif and from the right for Direction 2 Position PM_Direction_2_Number_of_Curves.gif. Clear if the curve is not required.

Options

Constrain to model When selected, the curves are updated if the model changes.
Ignore holes Use for imported surfaces with internal gaps or loops. When selected, the curves are generated across holes as though the surface were intact. When cleared, the curves stop at the edges of holes.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Face Curves PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23