Hide Table of Contents

End Cap PropertyManager

Parameters

PM_faces_to_mirror.gif Face Select one or more profile faces.
weldments_endcap_type2_01.gif
  Thickness direction Set the direction of the end cap. Select one of the following:

Outward

PM_End_Cap_thickness_direction_outward.gif Extends out from the structure, increasing the structure's overall length.

Inward

PM_End_Cap_thickness_direction_inward.gif Extends into the structure, retaining the original structure's overall length.
PM_direction1_thck.gif Thickness Set the thickness of the cap.

Offset

 

The end cap offset is the distance from the edge of the structural member to the edge of the end cap.
weldments_endcap_offset.gif
  Use thickness ratio Select to specify the offset distance using Thickness Ratio PM_distance1.gif (a value between 0 and 1). Then the offset is equal to the wall thickness of the structural member multiplied by the specified thickness ratio.

Clear to set a value for Offset Distance PM_distance1.gif.
  Chamfer corners Adds chamfers to the corners of the end cap.
weldments_endcap_chamfer.gif
PM_distance2.gif Chamfer Distance Set a value.
You can set the default color for End cap features in Model Display Options.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   End Cap PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59