Hide Table of Contents

Fillet Bead PropertyManager

Arrow Side

  Bead type
weldments_bead_full.gif weldments_bead_intermittent.gif
Full length Intermittent
weldments_bead_staggered01.gif weldments_bead_staggered02.gif
Staggered - Arrow Side Staggered - Other Side
PM_direction1_thck.gif Fillet size Length of the leg of the fillet bead.
  Bead length (For Intermittent or Staggered). Length of each bead segment.
  Pitch (For Intermittent or Staggered). Distance between the start of each bead.
  When you insert a bead across a gap:
weldments_bead_penetration_full.gif weldments_bead_penetration_partial.gif
Full penetration. Applies the bead to the full depth. Partial penetration. Applies the bead to the depth you enter in Penetration PM_thickness_3.gif.
  Tangent propagation
weldments_tangent_prop_selected.gif weldments_tangent_prop_cleared.gif
Selected Cleared
PM_face.gif Face Set1 Select one or more planar faces.
PM_face.gif Face Set2 Select one or more planar faces that intersect the first face set.
  Intersecting Edges Highlights edges where Face Set1 and Face Set2 intersect. You can right-click an edge and select Delete to remove it from the weld bead.

Other Side

Select Other Side to apply optional settings for Full Length and Intermittent types. If you selected Staggered as the Bead type, the Other Side is already displayed. Make selections as described for Arrow Side.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Fillet Bead PropertyManager
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.