You can create new standards or edit existing standards used by Hole Wizard holes and SolidWorks Toolbox components. You can add administrative access to these standards and the options of the SolidWorks Toolbox add-in.
You do not need to have SolidWorks Toolbox installed on your system to create or edit standards for Hole Wizard holes.
To create your own Hole Wizard standards:
- Click Options on the Standard toolbar, or click
- On the System Options tab, click Hole Wizard/Toolbox.
- Browse to the Hole Wizard and Toolbox folder location.
- Click Configure.
- In the Toolbox configuration tool, set options on the Smart Fasteners page.
For details, see Toolbox Help.
- Click Save, then close Toolbox.
- Click OK to close the System Options - Hole Wizard/Toolbox dialog box.
Click Reset to restore factory defaults for all system options or only for options on this page.