Hide Table of Contents

Relations/Snaps Options

Sketch options:

Enable snapping Sets all Sketch Snaps listed under Sketch Snaps.
With Enable snapping selected, all items under Sketch Snaps are selected by default except Grid.
Snap to model geometry Allows sketch entities to snap to model geometry such as edges.
Automatic relations Creates geometric relations as you add sketch elements.
Go To Document Grid Settings Sets options for the grid display and snap functionality.
Reset Restores factory defaults for all system options or only for options on this page.

Sketch Snaps

Clear or select all the types of Sketch Snaps.
Snap angle Lines snap in degree increments to the value you set.

When no other lines exist, the snap angle is based on the X-Y axes of the sketch origin.

If you sketch from the end of an existing line, the snap angle is based on the existing line.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Relations/Snaps Options
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.