Hide Table of Contents

3D Sketching Tools

Some of the tools you can use to create 3D sketches include:
  • All arc tools
  • All circle tools
  • All rectangle tools
  • Lines
  • Points
  • Splines
Spline on Surface is only available in 3D.
Additional tools include:
Centerline Tool_Centerline_Sketch.gif Creates construction geometry.
Convert Entities Tool_Convert_Entities_Sketch.gif Creates one or more entities in a 3D sketch by projecting an edge, loop, face, external curve, external sketch contour, set of edges, or set of external curves onto the sketch plane.
Face Curves Tool_Face_Curves_Sketch.gif Extracts 3D iso-parametric curves from faces or surfaces.
Sketch Fillet Tool_Sketch_Fillet_Sketch.gif Rounds the intersections of sketched lines.
Sketch Chamfer Tool_Sketch_Chamfer_Sketch.gif Bevels the intersections of sketched lines.
Intersection Curve Tool_Intersection_Curve_Sketch.gif Creates a sketched curve at intersections.
Trim Entities Tool_Trim_Entities_Sketch.gif Trims or extends a sketch entity in a 3D sketch.
Extend Entities Tool_Extend_Entities_Sketch.gif Extends a sketch entity in a 3D sketch.
Construction Geometry Tool_Construction_Geometry_Sketch.gif Converts sketched curves in a 3D sketch to construction geometry.
You cannot use:
  • Patterns
  • Offset


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   3D Sketching Tools
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.