Hide Table of Contents

Example: Curves Influence Options

To control your boundary feature design when creating boundary features from sketch curves, faces, edges, or other entities, you can experiment by changing the direction-based curves influence options.

Guide curve influence: Global globalgvsnextedgen.gif
Guide curve influence: Next Edge nextedgenvsglobalg.gifW
Guide curve influence: Global globalboibalvssharplincurve.gif
Guide curve influence: Next Sharp nextsharpnsharpvsgloblinnextedge.gif
Guide curve influence: Global globglobvslinlin.gif
Guide curve influence: Next Curve nextcurvevslinglobal.gif
Guide curve influence: Linear linearlinearvsglobalg.gif
Guide curve influence: Global pocketed_boundry_surface_global_5.gif
Guide curve influence: To Next Edge pocketed_boundry_surface_next_edge_5.gif
Guide curve influence: Linear pocketed_boundry_surface_linear_5.gif

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Example: Curves Influence Options
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.