> Example: Tangent Influence (%) Option

Introduction

Administration

User Interface

SolidWorks Fundamentals

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Example: Tangent Influence (%) Option

Dir1 and Dir2 curves influence: Global
All curves set to Tangent Type: Curvature to Face
Tangent influence (%) = 0

The flow of the boundary surface is curvature continuous, but you might want to inflate the surface more to minimize areas of rapidly changing curvature. Think of the surface as a balloon that you need to inflate more and the zebra stripes as topography lines.

This issue exists for very rounded shapes.

Dir1 and Dir2 curves influence: Global
All curves set to Tangent Type: Curvature to Face
Tangent influence (%) = 100

As you increase the Tangent influence (%), the zebra stripe pattern changes as the surface inflates.

Parent topic

Boundary PropertyManager

Related concepts

Boundary Surface

Search 'Example: Tangent Influence (%) Option' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Example: Tangent Influence (%) Option
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.