Hide Table of Contents

Revolves

Revolves add or remove material by revolving one or more profiles around a centerline. You can create revolved boss/bases, revolved cuts, or revolved surfaces. The revolve feature can be a solid, a thin feature, or a surface.

To create a revolve feature, use the following guidelines:
  • The sketch for a solid revolved feature can contain multiple intersecting profiles. With the Selected Contours pointer (available when you click Selected Contours in the PropertyManager), you can select one or more intersecting or non-intersecting sketches to create the revolve.
    Select top region (contour)
    Select bottom and mid regions (contours)
    Select mid region (contour)
    Select all regions (contours)
  • The sketch for a thin or surface revolved feature can contain multiple open or closed intersecting profiles.
  • The profile sketch must be a 2D sketch; 3D sketches are not supported for profiles. The Axis of Revolution can be a 3D sketch.
  • Profiles cannot cross the centerline. If the sketch contains more than one centerline, select the centerline you want to use as the axis of revolution. For revolved surfaces and revolved thin features only, the sketch cannot lie on the centerline.
  • You can create multiple radial or diametric dimensions without selecting the centerline each time.
  • When you dimension a revolve feature inside the centerline, you produce a radius dimension for the revolve feature. When you dimension across the centerline, you produce a diameter dimension for the revolve feature.
    You must rebuild the model to display the radius or diameter dimension symbol.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Revolves
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.