Hide Table of Contents

Sensors

Sensors monitor selected properties of parts and assemblies and alert you when values deviate from the limits you specify.

Sensor types include:
Mass Properties Monitors properties such as Mass, Volume, and Surface Area.
Dimension Monitors dimensions you select.
Interference Detection (Available in assemblies only.) Monitors the assembly for interferences between components you select.
Proximity (Available in assemblies only.) Monitors the assembly for interferences between a line you define and components you select. For example, use proximity sensors to model laser position detectors.
Simulation Data (Available in parts and assemblies, for use in SolidWorks Simulation.) Monitors:
  • Simulation data such as stresses, connector forces, and factors of safety on particular regions of the model
  • Results from Simulation transient studies (non-linear, dynamic, and drop-test studies)
Notifications appear at specified intervals to notify you about:
  • Sensors that have triggered alerts
  • Sensors that are out of date

Example of a notification:

Optionally, you can set an alert to notify you immediately when the sensor value deviates from the limits you specify. When a sensor triggers an alert, the sensor is flagged in the FeatureManager design tree.

Sensors and their current values appear in the Sensors folder in the FeatureManager design tree. Sensors are flagged to indicate the following conditions:
The sensor is not fully-defined or is out of date.
The sensor has triggered an alert.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sensors
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.