Hide Table of Contents

Sketch Status Conventions

Sketches can be in any of five states described below. The state of the sketch is displayed in the status bar at the bottom of the SolidWorks window.

Individual sketch entities (as opposed to entire sketches) also have sketch statuses.
Fully Defined All the lines and curves in the sketch, and their positions, are described by dimensions or relations, or both.
Over Defined Some dimensions or relations, or both, are either in conflict or are redundant. To view and remove conflicting relations, see Display/Delete Relations PropertyManager.
Under Defined Some of the dimensions or relations in the sketch are not defined and are free to change. You can drag endpoints, lines, or curves until the sketch entity changes shape.
No Solution Found The sketch is not solved. The geometry, relations, and dimensions that prevent the solution of the sketch are displayed.
Invalid Solution Found The sketch is solved but results in invalid geometry, such as a zero length line, zero radius arc, or self-intersecting spline.

With the SolidWorks software, it is not necessary to fully dimension or define sketches before you use them to create features. However, you should fully define sketches before you consider the part complete.

To always use fully defined sketches to create features, click Tools > Options > System Options > Sketch, and select Use fully defined sketches.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Status Conventions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.