Hide Table of Contents

Smart Weld Selection Tool

Use the Smart Weld Selection Tool to select faces to which you want to apply weld beads. The tool is available in the Weld Bead PropertyManager.

All weld beads have a weld path. The weld path is the course that the bead follows around the model.

When you create weld beads, two methods are available to specify where to apply weld beads:
  • Manual. Select edges or faces. You must click New Weld Path in the Weld Bead PropertyManager each time you create a new weld bead that has a disjoint weld path.
  • Smart Weld Selection Tool . Drag the pointer over the faces where you want weld beads. The software automatically creates new weld paths if you create a disjoint weld path.
For example, consider the following weldment part.
You want to create weld beads between each of the four support beams and the main beam.
There are four weld paths that you need to create.

Manual Selection

You can select two faces (or one edge), apply the weld bead, then click New Weld Path to create each additional weld path. If you do not click New Weld Path, a message tells you that the selected edge cannot form a continuous chain with the previously selected edges. In other words, the selection would make a disjoint weld path.

Smart Weld Selection Tool

You can drag the pointer over each pair of faces. The software automatically creates new weld paths because it recognizes that the paths are disjoint between each weld bead.

Video: Smart Weld Selection Tool



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Smart Weld Selection Tool
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.