Hide Table of Contents

Reference Axis PropertyManager

The Axis PropertyManager appears when you create a new axis or edit an existing axis.

To access the PropertyManager, click Axis (Reference Geometry toolbar) or Insert > Reference Geometry > Axis.

Selections

Reference Entities Displays the selected entities.
One Line/Edge/Axis. Select a sketch line, an edge, or select View > Temporary Axes and then select the axis that is displayed.
Two Planes Select two planar faces, or select View > Planes and then select two planes.
Two Points/Vertices Select two vertices, points, or midpoints.
Cylindrical/Conical Face Select a cylindrical or conical face.
Point and Face/Plane Select a surface or plane and a vertex point, or midpoint. The resultant axis is normal to the selected surface or plane through the selected vertex, point, or midpoint. If the surface is non-planar, the point must be on the surface.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Reference Axis PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.