Hide Table of Contents

Creating Weld Beads

  1. In a part, click Weld Bead (Weldments toolbar) or Insert > Weldments > Weld Bead . In an assembly, click Insert > Assembly Feature > Weld Bead .
  2. In the graphics area, select the faces or edges for the weld bead. Alternatively, use the Smart Weld Selection Tool to make selections.

    • Weld paths are supported between two bodies. You cannot define a weld path among three or more bodies or between the faces of one body.
    • Gaps between faces are supported.
    • Gaps between edges are not supported. Edges must lie on the surface of a body.

    A preview of the weld bead appears.

    A pink preview indicates that the weld path is active. A yellow preview indicates that the weld path is inactive. Any changes you make in the PropertyManager apply to the active weld bead.

  3. Set options in the Weld Bead PropertyManager.
  4. Under Weld Path, click New Weld Path to create additional weld beads. You do not need to click New Weld Path if you use the Smart Weld Selection Tool .
  5. Set options in the Weld Bead PropertyManager.
  6. Repeat steps 4 and 5 for additonal weld beads.
  7. Click .

    • A weld bead and weld symbol appear if you selected Weld Bead and All Annotations from the View menu.
    • The weld beads are added to the Weld Folder in the FeatureManager design tree, where they are grouped based on type and size.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Weld Beads
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.