Hide Table of Contents

Creating a Layout-based Assembly Design

In layout-based assembly design, you can switch back and forth between top-down and bottom-up design methods. You can create, edit, and delete parts and blocks at any point in the design cycle without any history-based restrictions. This is particularly useful during the conceptual design process, when you frequently experiment with and make changes to the assembly structure and components.

To create a layout:

  1. Open a new assembly.
  2. In the Begin Assembly PropertyManager, click Create Layout.

    A 3D sketch opens, and Layout appears in the FeatureManager design tree.

  3. Create sketch entities and group related entities into blocks.
  4. Close the blocks and the sketch.

    You can create a layout in an existing assembly by clicking Create Layout (Layout Tools toolbar).



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Layout-based Assembly Design
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.