Hide Table of Contents

Dynamic Clearance

You can dynamically detect the clearance between components when moving or rotating a component. As you move or rotate a component, a dimension appears indicating the minimum distance between the selected components.

Additionally, you can prevent two components from moving or rotating within a specified distance of one another.

To dynamically detect the clearance between components:

  1. Click Move Component or Rotate Component on the Assembly toolbar.
  2. In the PropertyManager, select Dynamic Clearance.
  3. Click in Components for Collision Check , select the components to check, then click Resume Drag.
  4. Click Stop at Specified Clearance and type a value in the box to prevent the selected components from moving within the specified distance.
  5. Drag one of the selected components in the graphics area.

    Notice a dimension appears in the graphics area and in the PropertyManager. This dimension is the minimum distance between the selected components; the dimension dynamically updates as you drag the component.

    Also, in the PropertyManager, a value appears in brackets. This is the minimum distance found during the drag operation.

  6. Under Advanced Options, select:
    Option Description
    Sound The computer beeps when the minimum distance in the Stop at Specified Clearance box is reached.
    Ignore complex surfaces Clearances are only detected on the following surface types: planar, cylindrical, conical, spherical, and torodial.

    The This configuration check box does not apply to Collision Detection, Physical Dynamics, or Dynamic Clearance. It applies only to Move Component or Rotate Component.

  7. Click to finish and exit.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Dynamic Clearance
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.