Hide Table of Contents

Rebuilding Blocks

Rebuild Block enables you to refresh sketch entities without exiting the Edit Sketch mode.

For example:

You have a sketch entity in the upper sketch that is constrained to a block with a coincident relation.

  1. Click Edit Block Tool_Edit_Block_Block.gif (Blocks toolbar) or Tools > Blocks > Edit to move the position of the sketch entity.

    The result is that the block is no longer coincident with the entity in the upper level sketch.

  2. Click Rebuild Block Tool_Rebuild_Block.gif (Blocks toolbar) or Tools > Blocks > Rebuild to re-establish the coincident relation again.

    This refreshes the entities while still in the sketch block editing mode.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Rebuilding Blocks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.