Hide Table of Contents

Replacing Multiple Sets of Faces

To replace more than one set of connected faces with surface bodies:

  1. Click Replace Face on the Surfaces toolbar, or click Insert > Face > Replace.
  2. In the PropertyManager, under Replace Parameters:
    1. Select the first set of faces to replace for Target faces .

      In this example, select the five faces along the top of the "H", including the vertical faces.

    2. Select the second set of faces to replace for Target faces .

      In this example, select the five faces along the bottom of the "H".

    3. Select the replacement surface for the first group of target faces for Replacement surfaces , then select the replacement surface for the second group of target faces for Replacement surfaces .

      You must select the replacement surfaces in the order that they replace the target faces.

  3. Click OK .

    The faces are replaced and the adjacent faces of the original body are trimmed and extended to fit. The new faces are trimmed to fit the adjacent faces of the original body.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replacing Multiple Sets of Faces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.