Hide Table of Contents

Sketching 3 Point Corner Rectangles

To sketch 3 point corner rectangles:

  1. Click 3 Point Corner Rectangle Tool_3_Point_Corner_Rectangle_Sketch.gif.
  2. In the graphics area:
    1. Click to define the first corner.
    2. Drag, rotate, and then release to set the length and angle of the first edge.
    3. Click and drag to sketch the other three edges.
    4. Release to set the four edges.
  3. Click PM_OK.gif.

    Video: Sketching 3 Point Corner Rectangles



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketching 3 Point Corner Rectangles
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.