Hide Table of Contents

Sketching Centerpoint Arcs

To sketch centerpoint arcs:

  1. Click Centerpoint Arc Tool_Centerpoint_Arc_Sketch.png.
  2. Click pointer_centerpoint_arc.gif to place the center of the arc.
  3. Release and drag to set the radius and the angle.
  4. Click to place a start point.
  5. Release, drag, and click to set an end point.
  6. Click PM_OK.gif.

    Video: Sketching a Centerpoint Arc



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketching Centerpoint Arcs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59