> Detailing and Drawings > Tables > Hole Tables > Adding Holes to a Table
Hide Table of Contents Show Table of Contents

Adding Holes to a Table

  1. Right-click the hole table in the FeatureManager design tree and select Edit Feature.
  2. Click in Edges/Faces, then select the holes in the graphics area.

    You may have to click Rebuild tool_Rebuild_Standard.gif (Standard toolbar) or Edit > Rebuild to update the table.



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding Holes to a Table
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SolidWorks 2013 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document SolidWorks 2013 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.