Hide Table of Contents

Opening Auto-Recovered Documents

You can open an auto-recovered document from the Task Pane. You can then delete it, save it by replacing the original file, or save it by creating a new file.

When you start SolidWorks after the system has terminated unexpectedly, any available auto-recovered documents are listed under Document Recovery on the SolidWorks Recovery tab of the Task Pane.

To open an auto-recovered document:

  • Double-click the document in the Document Recovery list, or right-click the document and click Open.

    You can then save the document either by using Save to replace the original file or by using Save As to create a new file.

    To delete an auto-recovered document, right-click the document and click Delete.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Opening Auto-Recovered Documents
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.