> Drawings and Detailing > Dimensions > Reference Center of Mass in Drawings > Inserting a Center of Mass in a Drawing
Hide Table of Contents Show Table of Contents

Inserting a Center of Mass in a Drawing

The part or assembly must include a center of mass.

To insert a center of mass:

  1. In a drawing, click Insert > Model Items.
  2. In the Model Items PropertyManager, under Reference Geometry, click Center of Mass Tool_center_of_mass.png.
  3. Click PM_OK.gif.

    You can create dimensions between the center of mass points and geometric entities using any of the dimensioning methods.

    To view the center of mass in a drawing, click View > Center of mass.



Related SolidWorks Forum Content

Provide feedback on this topic

SolidWorks welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting a Center of Mass in a Drawing
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: What's New 2013 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of DS SolidWorks or its licensors. The topics within the Web-based help are not beta topics; they document What's New 2013 SP05.

To disable Web help from within SolidWorks and use local help instead, click Help > Use SolidWorks Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.