Hide Table of Contents
SetCenterPoint2 Method (IRenderMaterial)

Sets the center point of the mapping for texture-based appearances.

.NET Syntax

Visual Basic (Declaration) 
Sub SetCenterPoint2( _
   ByVal CenterPt_X As System.Double, _
   ByVal CenterPt_Y As System.Double, _
   ByVal CenterPt_Z As System.Double _
) 
Visual Basic (Usage) 
Dim instance As IRenderMaterial
Dim CenterPt_X As System.Double
Dim CenterPt_Y As System.Double
Dim CenterPt_Z As System.Double
 
instance.SetCenterPoint2(CenterPt_X, CenterPt_Y, CenterPt_Z)
C# 
void SetCenterPoint2( 
   System.double CenterPt_X,
   System.double CenterPt_Y,
   System.double CenterPt_Z
)
C++/CLI 
void SetCenterPoint2( 
&   System.double CenterPt_X,
&   System.double CenterPt_Y,
&   System.double CenterPt_Z
) 

Parameters

CenterPt_X
x coordinate of the center point of the mapping
CenterPt_Y
y coordinate of the center point of the mapping
CenterPt_Z
z coordinate of the center point of the mapping

Remarks

This method is required to properly position a texture-based appearance (e.g., if you need a specific corner of a face to have the black square of a checkered-pattern appearance).

 

See Also

Availability

SolidWorks 2013 SP05, Revision Number 21.5


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   SetCenterPoint2 Method (IRenderMaterial)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.