> eDrawings Basics > Saving Files > Saving Files as STL Files
Hide Table of Contents Show Table of Contents

Saving Files as STL Files

You can save part and assembly files as STL files using binary or ASCII format. Binary files are smaller than ASCII files, but they are not supported in some other systems.

If cross sections are shown in the model, they are not shown in the STL file.

The STL file always uses meters for the unit of measure. All measurements from the original file are converted into the equivalent value in meters in the STL file.

To save a file that you received from another user as an STL file, the sender must have set the option to give you permission. See eDrawings Save Options and Creating eDrawings Files Using SolidWorks Save As.

To save files as STL files:

  1. Click File > Save As.
  2. Set Save as type to STL Files (*.stl).
  3. Type the File name, then click Save.
  4. In the STL Export Options dialog box, under Format, select Binary or ASCII.
  5. Click OK.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Saving Files as STL Files
*Comment:  
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: eDrawings 2013 SP05

The search functionality within the web help is in a beta test phase and you may experience periodic delays or interruptions in its performance. These are the normal and ordinary features of a beta test and shall not under any circumstances give rise to any liability on the part of Dassault Systèmes SolidWorks Corporation or its licensors. The topics within the Web-based help are not beta topics; they document eDrawings 2013 SP05.

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.