Hide Table of Contents

PropertyManager

In the SolidWorks software, PropertyManager is available for editing properties such as coordinates, angles, and other values for the entity (POINT, LINE, CIRCLE, ELLIPSE, or POLYGON) that you draw. The properties available are different for each type of entity.

To enable the PropertyManager, click Tools > Options > System Options > General and select the Enable PropertyManager check box. When you finish drawing an entity, the PropertyManager appears at the left of the graphics area. Edit a value and click elsewhere on the PropertyManager to see the change in the graphics area. To close the PropertyManager, click in the graphics area or type a new command.

The PropertyManager also appears when you select an entity of a type handled by the PropertyManager, or when you issue a command, such as MOVE or COPY, that affects an entity.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.