Hide Table of Contents

LINE (L)

Draws straight line segments.

Specify:

1 From point
2 To point

Specify coordinate values (XY) or point and click in the graphics area. The second prompt loops so that you can continue specifying points to generate a series of line segments.

Each segment is a separate entity.

To close, type C at the To point prompt. A line is drawn from the last point to the first, closing the figure and ending the procedure.

To exit the command without closing the figure, press Enter or Esc, or right-click.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   LINE (L)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.