Hide Table of Contents

Via Group Properties

Vias form the vertical electrical connections between different layers in a circuit board. You can view via group properties.

To view Via Properties, from the tree view, right-click Vias, and select Properties.

Name Specifies a name for the via.
X Value (mm) Specifies the X-coordinate of the via center.
Y Value (mm) Specifies the Y-coordinate of the via center.
Via Diameter (mm) Specifies the diameter of the copper conductor.
Hole Diameter (mm) Specifies the diameter of the optional hole through the center of the via.
Filter Status Specifies the filter status:

Filtered In

Filtered Out



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Via Group Properties
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59