Hide Table of Contents

Running Specifications

Once you have set up your project, you are ready to generate new models.

To generate new models:

  1. On the Welcome page, select Run Models and click .
  2. Select a model from the Ready to Run list.
  3. Click .

    The form is displayed with default values. Required fields are highlighted and have tool tips .

  4. Enter values and use controls to complete the form:
    • Click Last Used to insert the last set of data entered on the form.
    • Click Defaults to insert the data specified as default when the form was created.
    • Click Clear to remove all entries.
  5. Click Create to generate new models and drawings.

    The results report, which lists actions completed successfully and any errors generated , includes this information:

    • Whether the master file was opened successfully and the new model saved
    • The names and location of new models and drawings
    • Parameters captured and driven (the DriveWorksXpress Name, SolidWorks Name, and the value from the Form)
    • Property rule sets

  6. Click to correct any problems, or click to create another model from the same specification.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Running Specifications
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26