Hide Table of Contents

Dynamic Mirror Sketch Entities

Select the Dynamic Mirror Entities Tool_Dynamic_Mirror_Entities_Sketch.gif tool to first select the entity about which to mirror, and then sketch the entities to mirror. If you want to mirror pre-existing sketch entities, select the Mirror Entities Tool_Mirror_Entities_Sketch.gif tool.

To display this PropertyManager, in an open sketch, click Dynamic Mirror Entities Tool_Dynamic_Mirror_Entities_Sketch.gif (Sketch toolbar).
You can mirror 2D sketches or 3D sketches on sketch planes.
You can mirror sketches about any these entities:
  • Centerlines
  • Lines
  • Linear model edges
  • Linear edges on drawings
To mirror about a linear drawing edge, the sketch entities to mirror must lie within the boundary of the drawing.
mirror_about_drawing_edge01.gif mirror_about_drawing_edge02.gif
As you sketch the entities, they are mirrored about the pre-selected sketch entity. Restrictions to Dynamic Mirror Entities include:
  • Pre-existing sketch entities cannot be mirrored.
  • Both the original and the mirrored sketch entities are included in the final result.
dynamic_mirror_entities_select.gif dynamic_mirror_entities_sketch.gif
Select the sketch entity about which to mirror. Only the newly sketched entities are mirrored.

Mirroring Sketch Entities as You Sketch Them

To mirror sketch entities as you sketch them:

  1. Select a line or a model edge in an open sketch.
  2. Click Dynamic Mirror Entities Tool_Dynamic_Mirror_Entities_Sketch.gif (Sketch toolbar) or Tools > Sketch Tools > Dynamic Mirror.

    Symmetry symbols appear at both ends of the line or edge.

  3. Create the sketch entities that you want to mirror. The entities are mirrored as you sketch them.
  4. To turn mirroring off, click Dynamic Mirror Entities Tool_Dynamic_Mirror_Entities_Sketch.gif again.

    Video: Dynamic Mirror Sketch Entities



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Dynamic Mirror Sketch Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.