Hide Table of Contents

Cross Break PropertyManager

Use the Cross Break PropertyManager to add a graphical representation of a cross break to a sheet metal part.

To display the PropertyManager, click Cross Break (Sheet Metal toolbar), or Insert > Sheet Metal > Cross Break.

Faces Face on which the cross break is inserted.
Reverse Direction Reverses the direction of the cross break in relation to the selected face.
  Edit Cross Profile Click to edit the profile sketch of the cross break to move corners and change relationships.

The lines defining the sketch must intersect and the endpoints must be constrained to the edges.

Break Radius Radius to be used to create the cross break.
Break Angle Angle to be used to create the cross break.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Cross Break PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59