Hide Table of Contents

Arcs

You can sketch the following arc types:
Arc types Tool Arc properties
Centerpoint Arc Tool_Centerpoint_Arc_Sketch.png Sketches arcs from a centerpoint, a start point, and an end point.
Tangent Arc Tool_Tangent_Arc_Sketch.gif Sketches arcs that are tangent to sketch entities.
3 Point Arc Tool_3_Point_Arc_Sketch.png Sketches arcs by specifying three points (start, end, and midpoint).
The SolidWorks application defaults to the last used arc type.

To access the arc tools:

  • Sketch tab. Click the Arc CommandManager to select arc tools from the Arc arc_flyout_sketch.png flyout tool.
  • Menu. Click Tools > Sketch Entities to select arc tools.
  • Arc PropertyManager. Change to different arc tools from the Arc PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Arcs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.