Hide Table of Contents

Defining Initial Simulation Studies

When using simulation data sensors in a Design Study, you create at least one initial study. Initial studies represent the basis for the optimization or the evaluation process. During each iteration, the program runs these studies with modified variables.

The required initial studies depend on the constraints and goals you select. For example, a goal to minimize the volume or weight does not require an initial study of a particular type, but a goal to minimize the frequency requires an initial frequency study. The frequency simulation study provides the information to the frequency sensor to be used by the Design Study.

The same rule applies to constraints. Each constraint you specify must be associated with a compatible initial study. For example, to define constraints on stress, frequency, and temperature, you must define static, frequency, and thermal studies, respectively.

All studies referenced in defining constraints and goals must belong to the same configuration.

After creating your model and dimensioning it to the best of your knowledge, create the initial studies and define their properties, materials, loads, and restraints. It is not recommended to use more than one study of the same type in an optimization problem.

Evaluating the Results of the Initial Studies

If using the simulation studies in your Design Study, evaluating the results of the initial studies helps you define the Design Study problem. In particular, it is useful to examine the quantities that you want to use as constraints.

The results of the initial studies give you a good idea of what the current values of the sensors are. Do not specify constraints or goals that are far away from the current values, therefore making an optimization impossible. Before performing an optimization, try running simulations for a range of variable values, especially dimensions, to make sure that the model rebuilds at each value.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Defining Initial Simulation Studies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.