Hide Table of Contents

Error Message - Check Sketch for Feature

The Check Sketch for Feature tool examines sketches for errors in contour that might prevent a feature from being created. It checks for error that are common to all contour types, and, if you select a feature type, it also checks the contour type required for the feature type. When errors are diagnosed, the problem geometry is highlighted.

This example checks a sketch for use in creating a Base Revolve feature.

To check a sketch:



  1. In an open sketch, click Tools > Sketch Tools > Check Sketch for Feature.
  2. For Feature Usage, select Base Revolve.

    Multiple Disjoint Closed is displayed as the Contour type.

  3. Click Check.

    A diagnostic message is displayed, and the corresponding extraneous line is highlighted.

    The sketch cannot be used for a feature because an endpoint is wrongly shared by multiple entities.

  4. Delete the highlighted line.
  5. Click Check again.

    The same message appears and a different extraneous line is highlighted.

    The sketch cannot be used for a feature because an endpoint is wrongly shared by multiple entities.

  6. Delete the highlighted line.
  7. Click Check again.

    A new message indicates that the highlighted line is not connected to the intersecting lines.

    The sketch has more than one open contour.

  8. Trim one end of the line and extend the other end.
  9. Click Check again.

    Now all the errors have been found and corrected.

    No problems found. The sketch contains 1 closed contour(s) and 0 open contour(s).

  10. Click Close.

To create the base revolve feature:

  1. Click Revolved Base/Boss (Features toolbar) or Insert > Base/Boss > Revolve.
  2. Select the line shown as the axis of revolution.
  3. Click to complete the feature.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Error Message - Check Sketch for Feature
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.