Hide Table of Contents

Rectangles

You can sketch the following rectangle types:

Rectangle type Tool Rectangle properties
Corner Rectangle Tool_Rectangle_Sketch.png Sketches standard rectangles.
Center Rectangle Tool_Center_Rectangle_Sketch.gif Sketches rectangles at a center point.
3 Point Corner Rectangle Tool_3_Point_Corner_Rectangle_Sketch.gif Sketches rectangles at a selected angle.
3 Point Center Rectangle Tool_3_Point_Center_Rectangle_Sketch.gif Sketches rectangles with a center point at a selected angle.
Parallelogram Tool_Parallelogram_Sketch.gif Sketches a standard parallelogram.
The SolidWorks application defaults to the last used rectangle type. You can also use the rectangle tools (Sketch toolbar).
To access the rectangle tools:
  • Sketch tab. Click the Rectangle CommandManager, to select rectangle tools from the Rectangle Rectangle_flyout.gif flyout tool.
  • Menu. Click Tools > Sketch Entities to select rectangle tools.
  • Rectangle PropertyManager. Change to different rectangle tools from the Rectangle PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Rectangles
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.