Hide Table of Contents

Crop View

A crop view focuses on a portion of a drawing view by hiding all but a defined area. The uncropped portion is enclosed using a sketch, usually a spline or other closed contour.

You can crop any drawing view except a Detail View or a view from which a Detail View has been created. Crop View can save steps because you do not create a new view. For example, instead of creating a Section View and then a Detail View, then hiding the unnecessary Section View, you can crop the Section View directly.

Cropping a View

To crop a view:

  1. In a drawing view, sketch a closed profile such as a circle.
  2. Click Crop View tool_Crop_View_Drawing.gif (Drawing toolbar), or click Insert > Drawing View > Crop.

    The view outside the profile disappears.

    A circle is drawn on this Section View After cropping, only the view inside the circle is displayed.
    drw_crp1_shg.gif drw_crp2_shg.gif

Editing a Crop View

To edit a Crop View:

  1. Right-click the drawing view in the graphics area or in the FeatureManager design tree and select Crop View > Edit Crop.
  2. Edit the profile.
  3. Click Rebuild tool_Rebuild_Standard.gif to update the view.

Removing a Crop View

To remove a Crop View:

  • Right-click the drawing view in the graphics area or in the FeatureManager design tree and select Crop View > Remove Crop.

    The crop is removed and the view returns to its uncropped state.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Crop View
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59