Hide Table of Contents

Disabling the SpeedPak Graphics Circle

You can disable the SpeedPak graphics circle so that the geometry in the region surrounding the pointer remains visible even if it is not selectable.

To enable or disable the SpeedPak graphics circle:

  • Do one of the following:
    • Click Tools > Options > Display/Selection and select or clear Display SpeedPak graphics circle.
    • Press Alt + S.

    When the graphics circle is on, only selectable geometry is visible in the region surrounding the pointer.
    SpeedPak_circle_on.png

    When the graphics circle is off, all geometry in the region surrounding the pointer remains visible. If the pointer is over a SpeedPak entity that is not selectable, the pointer changes to pointer_SpeedPak_graphics_circle_off.png.
    SpeedPak_circle_disabled.png



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Disabling the SpeedPak Graphics Circle
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23