Hide Table of Contents

Simplified Representations of Assemblies

When you want to work on a small subset of components in a large assembly, you can improve assembly performance by opening a simplified representation of the assembly. You specify which components to load; other components are not loaded and not visible, but the effects of their mates are retained.

You can specify to fully load the specified components, or to load them as lightweight.

You can specify components to load by selecting:
  • Individual components.
  • A display state where you previously defined the show/hide state of the components.
To take advantage of the Selective Open functionality (in which hidden components are not loaded), files must be in the current version of SolidWorks.

To open a simplified representation of an assembly:

  1. Click Open (Standard toolbar) or File > Open.
  2. In the Open dialog box:
    1. Browse to the assembly you want to open.
    2. Under Mode, select Large Design Review.
    3. Click Open.

      The assembly opens in Large Design Review mode.

  3. On the CommandManager, click Selective Open or Selective Open in Lightweight .

    The following appear:

    • The Selective Open dialog box.
    • A preview of the assembly.
    • A simplified FeatureManager design tree showing only components.
      In the FeatureManager design tree:
      • indicates a subassembly that was last saved in a SpeedPak configuration.
      • indicates a subassembly that has a SpeedPak configuration available, although the subassembly was last saved in another configuration.
      See Opening Assemblies Containing SpeedPak Subassemblies.

  4. Make selections in the dialog box and click Open Selected or Open.

    When the assembly opens:

    • The components you have specified are loaded.
    • All other components are not loaded and not visible, but the effects of their mates are retained.
    • A new display state appears on the ConfigurationManager tab.
    Because hidden components are not loaded into memory, you might notice a delay when you first show a hidden component, because the software must load it then.

Contents

  • Selective Open Dialog Box

    In the Selective Open dialog box, you specify which components to load. Other components are not loaded and not visible, but the effects of their mates are retained.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Simplified Representations of Assemblies
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59