To create a fillet in a sketch:
- In an open sketch, click Sketch Fillet on the Sketch toolbar, or .
- Set the properties in the Sketch Fillet PropertyManager.
- Select the sketch entities to fillet.
You can select non-intersecting entities. The entities are extended at a virtual intersection, and the corner is filleted.
To select the sketch entities, you can select two sketch entities or select a corner.
|
|
When you select a sketch entity, then hover over another sketch entity, a preview appears. |
When you select the second sketch entity, the preview changes colors. |
|
|
When you hover over a corner, a preview appears. |
When you select the corner, the preview changes colors. |
- Drag the preview to adjust the fillet size if necessary.
- Click to accept the fillet.