Hide Table of Contents

Suspending Automatic Rebuilds

You can defer the update of assemblies until you are ready to rebuild the assembly. By deferring the update, you can make many changes, then rebuild the assembly once. The assembly still rebuilds automatically, if necessary, for internal updates and to protect the integrity of the model.

Use this option only when absolutely necessary. Rebuild errors created while this option is active will not become apparent until this option is deactivated (or you do a manual rebuild), which can make it difficult to determine the cause of the errors.

To defer the update of assemblies:

  • Right-click the assembly name at the top of the FeatureManager design tree, and select Suspend Automatic Rebuild.

    (Rebuild Suspended) appears in the status bar.

To manually update when in Suspend Automatic Rebuild mode, click Rebuild on the Standard toolbar.

To turn off the option, right-click the assembly name at the top of the FeatureManager design tree, and clear Suspend Automatic Rebuild.

You must reset the option every time you load the assembly document.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Suspending Automatic Rebuilds
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59