Hide Table of Contents

Using Detach Segment on Drag

You can detach a segment (line, arc, ellipse, or spline) from the other entities it is attached to in a sketch, if dimensions or relations do not prevent dragging.

Detach Segment on Drag is not available in 3D sketches.

Detach Segment On Drag does not delete relations. Delete relations before you drag an entity to detach. See Display/Delete Relations PropertyManager.

To detach a sketch segment:

  1. In an open part, click Tools > Sketch Settings > Detach Segment on Drag.
  2. Select the entity that you want to detach from another sketch entity and drag it to a new location.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Using Detach Segment on Drag
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.