Hide Table of Contents

Table Anchors

Anchors position tables with respect to a drawing sheet format. Each type of annotation table has its own anchor point in a drawing sheet format.

When you do not attach a table to an anchor point, you can drag it to endpoints or lines in the sheet format.

To set a table anchor point:

  1. In the FeatureManager design tree, expand Sheet Format FM_Sheet_Format.gif for the active drawing sheet.
  2. Right-click the anchor you want to set and select Set Anchor. Choose from:

    FM_general_table_anchor.gif General Table Anchor FM_Revision_Table.gif Revision Table Anchor
    FM_BOM.gif Bill of Materials Anchor FM_Weld_Table.gif Weld Table Anchor
    FM_Hole_Table.gif Hole Table Anchor FM_Bend_Table.gif Bend Table Anchor
    FM_Weldment_Table.gif Weldment Cut List Anchor FM_Punch_Table.gif Punch Table Anchor

  3. Click in the graphics area to specify the anchor point.


    bomsplainbom.gif



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Table Anchors
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.