Hide Table of Contents

Standard Hole Size

Verifies if holes in the part or assembly document comply with the standard hole sizes created with Simple Holes or the Hole Wizard.

Activate Standard Hole Sizes through Feature Checks . For example, this check included a Custom Throughhole with a non-standard diameter of 0.3420.

Parameter Name Remarks
Standard Hole Sizes Custom Throughhole Diameter: 03240
Standard Throughhole Diameter: 0.24320
Tapered Drill and Tapered are not supported for Legacy Hole types.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Standard Hole Size
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2013 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26