Hide Table of Contents

Replication Settings Dialog Box

Use the Replication Settings dialog box to configure a Replication server for on-demand replication of a vault archive.

To display this dialog box:

Run the replicated archive server wizard. When you complete the login to the replication server, the dialog box displays.

Connections

Select a connection to modify it.

Use the Selected connection section to make changes.

Test

Select Test and then press the Test button to test the replication connection from the Source server to the Target server.

IP address or DNS name

Enter a valid DNS system name or IP address that the Target Server can use to communicate with Source Server.

In a WAN environment, you should use the IP address here. The archive servers will communicate over TCP port 3030, so make sure that port is fully opened in any firewall between the servers.

Speed

Balance the replication load between three or more servers. Server connections with a higher speed rating take priority over servers with a lower speed rating.

If you are replicating between two servers, you should select the highest speed rating (10 Mbit) regardless of real connection speed. The speed setting does not affect the actual replication transfer speed in any way, only priority.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Replication Settings Dialog Box
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2014 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.